Swapped my 0.5mm lead for 0.3mm on a residential job last week and I'm never going back.

I was laying out some floor plans for a kitchen remodel over on Elm Street and the fine details on the cabinet elevations were just a mess with my usual 0.5. My coworker handed me his 0.3mm for a test run and the difference in precision on those tight corners was night and day. Less erasing too, somehow. Has anyone else made a similar switch and stuck with it?

1 comments

1 Comment

the_nina6h ago

Going back to 0.5 after trying 0.3mm is like going back to dial-up after fiber, I just can't do it.